Room Sensor - Harman Home Heating P68 Owner's Manual

room Sensor and rear Shield installation
room Sensor installation
The room sensor is a small temperature sen-
sor on the end of a 60" gray wire. This sensor is
installed much like a standard wall thermostat. Be-
cause it is so small, it can be hidden along the trim
of a doorway or even up the leg of a coffee table.
There is a remote room sensor port on the rear of
the unit for easy external connection. Use standard
18-2 thermostat wire to extend the distance to the
desired location (50' maximum). The room sensor
should be installed in the location where you want
to control the temperature.
In most installations locating the room sensor
behind the stove near the distribution fan works well
because the sensor monitors the room air being
drawn into the distribution fan.
NOTE: Distances of more than 25 feet from
the unit or in another room are not recommended.
The room sensor is essential for the P68's excellent
efficiency.
NOTE: it is recommended that the room
sensor be installed, even if only installed on the
rear of the unit as a return air sensor.
22
P68 Pellet Stove
Fig. 2
rear Shields
Room
Sensor
Port
5/16" Hex Head
Screws (3 on
each side)
The rear insulated shields are split in the middle for
easy removal. Each shield has () 5/16" hex head
screws. Two (2) that only need to be loosened, and
one (1) that needs to be completely removed, to
allow the shield to slide away from the unit. nOte:
it is not recommended that the unit be operated
with the shields removed, due to the hot and
moving parts which they protect.
5/16" Hex Head
Screws (3 on
each side)
Fig. 25