& Operating Manual Cleaning & Maintenance Instructions P61A Pellet Stove Owners Manual “Ce manuel est disponible en Français sur demande” SAFetY nOtice PleASe ReAd thiS entiRe MAnuAl beFORe YOu inStAll And uSe YOuR new ROOM heAteR. FAiluRe tO FOllOw inStRuctiOnS MAY ReSult in PROPeRtY dAMAge, bOdilY injuRY, OR even deAth.
Lay the glass retainers into position and install the screws. Tighten each screw evenly to avoid making any stress points. P61A Pellet Stove...
Page 3
. Brush or scrape the inside of the stove to remove fly ash. Blower 4. Scrape burnpot with flat end of scraper provided Wheel with the stove. Inspect the holes on the burnpot surface. See Fig. . 5. Open burn pot clean-out. Clean fly ash from burn Blower Cover Latch pot and replace cover. Fig 27 P61A Pellet Stove...
Page 4
The stove should be cleaned after each ton of pellets (50 bags) and the venting system inspected and cleaned after each heating season. Fig. 33 Probe Be careful not to damage ESP probe when cleaning with brush. Fig. 31 P61A Pellet Stove...
Igniter hot lead wires (high temperature) note: the hot lead/cold lead connection must always be pulled to the rear of the Burn pot igniter feeder body before operation. Viewed from below through the ash pan opening. Fig. 36 P61A Pellet Stove...
If the switch opens when the cycle is at rest, the power lights for the feed motor or igniter will not illuminate. Be sure all doors, including the hopper lid, are securely closed when operating the appliance. P61A Pellet Stove...
Premium at 1% or less, Standard at % 3. The air chamber under the burnpot may be filled or less and all others at % or more. with fines and small bits of ash. The P61A is capable of burning all categories of pellets due to a patented feeder and burn pot sys- 4. The holes in the burnpot may be getting filled tem.