Harman Stove Company XXV Installation & Operating Manual page 17

Stove temperature Mode
In the Stove Temperature Mode and with the igniter
toggle switch in the Auto position, the stove will light
automatically and can be adjusted to the desired setting
using the same temperature control dial as is used in
the Room Temperature Mode. The heat output and fuel
consumption will remain constant regardless of room
temperature. The settings from 1 to 7 on the inner ring
of the dial provide for relative heat output settings with
1 being low and 7 being the maximum.
In Stove Temperature Mode, the stove will not
automatically shut off unless the stove runs out of fuel
or is turned off.
Never disconnect the power cord to shut down the
stove. This will stop the combustion blower and smoke
will escape through window and door gaskets.
Feed adjuster knob
For most premium grade pellet fuels, the feed
adjuster should be set at #4. If high-ash fuel is used,
the setting may need to be adjusted to #5 or 6. Higher
settings are also needed if you want to achieve the
maximum capacity of the stove. Just be sure that when
burning at maximum, Stove temperature mode with the
feed adjuster on #6 and the temperature knob on "7"
or "90°", the pellets are not falling off of the front of the
burn pot before they have a chance to burn completely.
You should try to keep about one inch of ash in front of
the burning pellets.
Shut down Procedure
The best way to shut down the stove is to simply let it
run out of pellets, the stove will shut down automatically.
Alternatively, you can turn the Mode Selector to "off".
This will cause the fire to gradually die down and go out.
The fire will not go out immediately and may take more
than an hour to fully shut down.
If the stove is left to run out of fuel, you may get a
6 blink status light. If this happens simply reset the
control board by turning the mode selector to OFF and
back ON.
AUTOMATIC IGNITION/OPERATION
Stove temperature Mode
This setting, see above, will produce continuous medium
heat output with the distribution blower at low speed.
This setting, see above, will produce continuous maximum
heat output with the distribution blower at full speed.
Fig. 21
17
XXV Pellet Stove