Harman Kardon BDP 10 Owner's Manual page 16

INSTALLATION
Figure 6 – Remote IR Input and Output
Step Six – Network Connection
Connect the Network Jack to a router or Ethernet-compatible
controller. See Figure 7. The network connection is used for BD-Live
discs to access the Internet for updates to the disc content and
special features. A USB drive with at least 1GB capacity is required for
BD-Live functionality. Select the "Storage" option in the USB Function
Select menu.
Figure 7 – Network Jack
Step Seven – Plug In AC Power
To avoid possible damage from a transient power surge at plug-in,
turn off the Master Power Switch. Plug the female end of the AC
Power cord into the receptacle (see Figure 8), and the male end into
an unswitched AC outlet.
Figure 8 – Master Power Switch and AC Power Input
16
Step Eight – Insert Batteries in Remote
The BDP 10 remote control uses two AA batteries (included).
To remove the battery cover located on the back of the remote, lift
the tab until the latch releases, and lift the battery cover up. Insert the
batteries as shown in Figure 9, observing the correct polarity.
To replace the cover, insert the two small tabs at the top of the cover
into the recesses at the top of the battery compartment, and lower the
cover, pressing the latch at the bottom until it snaps shut.
Point the remote toward the front panel of the BDP 10. The IR receiver
is located immediately to the right of the Message Display. Make sure
no objects are blocking the remote's path. Bright lights, fluorescent
lights and plasma video displays may interfere with the remote's
functioning. The remote has a range of about 6 m, depending on the
lighting conditions. It may be used at an angle of up to 30 degrees to
either side of the BDP 10.
If the remote seems to operate intermittently, make sure the batteries
have been inserted correctly, or replace both batteries with fresh ones.
Figure 9 – Remote Battery Compartment