Harman Kardon BDP 10 Owner's Manual page 12

REAR-PANEL CONNECTIONS
Remote Infrared (IR) Input and Output: When the front-panel
Remote IR sensor is blocked, connect the IR Output of your receiver/
processor or an optional IR receiver to the Remote IR Input jack. The
Remote IR Output may be connected to the Remote IR Input of a
compatible product for remote control through the BDP 10. When
several devices are used, connect them in "daisy chain" fashion.
Composite Video Output: If your video display does not have HDMI
or component video inputs, connect this video output to your A/V
receiver/processor or directly to the display.
Component Video Outputs: If your A/ V receiver, surround processor
or video display is not equipped for HDMI or DVI, connect these jacks
to the corresponding inputs on the receiver or TV. If your video display
has component input jacks marked "High Definition," use those jacks.
Analog Audio Outputs: If you are not using either HDMI or a separate
optical or coaxial digital audio connection, connect these jacks to the
A/V receiver or TV. Connect these jacks in addition to a digital audio
connection to make recordings for personal use, or for a multizone
system.
Coaxial and Optical Digital Audio Outputs: If your A/ V receiver
or surround processor is not capable of processing the audio from an
HDMI stream, connect either of these digital audio outputs (but not
both) to the receiver/processor.
12
HDMI Output: Connect to an HDMI-compatible A / V receiver or video
display device. If your A/ V receiver or surround processor is capable of
decoding audio from the HDMI stream, no further audio connection is
needed.
NOTE: If your A/V receiver or video display uses DVI connections,
use an optional HDMI-to-DVI adapter or cable, and make a
separate audio connection. If your DVI-equipped display is not
HDCP-compliant, you must use an analog video connection.
Network Jack: Connect this standard RJ45 jack to a broadband
network (Ethernet) connection so that you may take full advantage
of BD-Live updates, features and enhancements of the BonusView
system. BD-Live functionality requires a USB drive with at least 1GB
capacity to be inserted in the USB Port, with the "Storage" function
selected in the USB Function Select menu. When the network
connection is "live," the lights on either side of the jack will flash to
indicate network activity.
NOTE: When the BDP 10 is used with an IP-based or wireless
control device, connect a router/access point here, making certain
that one connection runs from the router to a broadband Internet
connection.
Master Power Switch: Flip on to apply power to the BDP 10,
placing it in the Standby mode. When the unit will not be used for an
extended period of time, or whenever it is necessary to remove the
unit from the AC power lines, flip the switch off.
AC Power Input: Connect the supplied AC power cord to this socket
first, and then to an unswitched AC outlet. Should the cord become
damaged, contact your authorized Harman Kardon dealer for a
replacement.
Fan Vents: This area contains vents used by the BDP 10's fan to cool
the system. Maintain a clearance of at least 3 inches to the nearest
surface, to avoid overheating the unit.