Charging The Battery - Husky MP2500 User Manual

Hand-held computer
Hide thumbs Also See for MP2500:
Table of Contents

Advertisement

After changing the battery, you MUST ensure
that the battery type and whether or not it is
rechargeable are correctly configured. (Refer the
section SETTING UP above, or to your
application's user instructions.)
CAUTION: If you fit Alkaline batteries, warn anyone that you
give the unit to – non-rechargeable batteries must NOT be
recharged.
Always use batteries of the same type and charge state – don't
mix fresh batteries with used batteries, or rechargeable
batteries with non-rechargeable ones.
Observe the instructions printed on the battery. Replace only
with batteries approved by your MP2500 supplier. DO NOT FIT
LITHIUM BATTERIES.
ATTENTION: Dispose of or recycle used batteries according to
the manufacturer's instructions, or local waste management
regulations. Nickel-Cadmium rechargeable batteries must be
recycled, or disposed of properly. Do not dispose of batteries
in fire.
CAUTION: BATTERY CHEMICAL LEAKAGE IS CORROSIVE. In
the unlikely event of battery leakage, do not touch. In case of
accidental contact, flush immediately with running water.

Charging the battery

If you are using the rechargeable battery pack,
charging is recommended before each working shift.
You will need a H
USKY
CAUTION: DO NOT ATTEMPT TO RECHARGE
NON-RECHARGEABLE BATTERIES. DAMAGE TO
THE MP2500 WILL RESULT
MP2500 rechargeable battery pack is fitted to
your MP2500, and oriented correctly. Use only
the MP2500 AC Adaptor. Refer to the AC POWER
ADAPTOR section for full precautions before use.
Turn off the MP2500.
Plug the AC adaptor into the AC supply.
Connect the AC adaptor to the 9 pin connector at
the top of the unit.
Turn on the AC supply.
The MP2500 should display Charging in
progress (if not, ensure charging is enabled -
see SETTING UP, steps 6 and 7).
Leave the unit to recharge, for example overnight or
until it displays Charging complete.
Turn off or disconnect from the AC supply.
Alternatively, if your system includes a H
Communications & Charging Rack (CCR), you
can recharge a unit by placing it on the Rack.
MP2500 AC Adaptor.
. Make sure a H
USKY
USKY

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents