Ac Power Adaptor - Husky MP2500 User Manual

PROBLEMS
If you have problems with the MP2500, TELL YOUR
SYSTEM PROVIDER, but here are a few checks:
If the unit will not turn on, check the battery pack
orientation and try another charged battery pack.
If you cannot read the display, try adjusting the
screen contrast (see CONTROLS).
If you drop the unit and it stops working, try
turning off and on, and check the battery pack.
Your application may provide a RESET facility,
or you may be able to reset the unit as described
in the CONTROLS section.
CAUTION: There are no user serviceable parts
inside the MP2500, and high voltages can be
present. Do not attempt to open.

AC POWER ADAPTOR

The MP2500 (or the H
Charging Rack) is normally supplied with a H
AC Power Adaptor (power supply).
CAUTION: Read and understand the following
instructions before using the ac power adaptor.
Hazardous voltages inside, no user serviceable parts inside, do
not attempt to open.
Indoor use only.
Avoid liquid spillage, do not connect if suspected damp.
Ensure ventilation is not restricted.
Use only the H MP2500 (or MP CCR) AC Adaptor. The
USKY
H adaptor should never be replaced by an alternative
USKY
unapproved model - this could be hazardous or cause damage.
Inspect the adaptor before connecting, do not use if there are
signs of damage or deterioration.
Ensure rechargeable batteries are fitted and they are orientated
correctly.
Ensure that connectors are firmly mated.
Avoid mechanical strain to cables or connectors.
Switch on or connect the mains (line) supply only after making all
connections.
Switch off or disconnect the mains (line) supply before
disconnecting the AC Adaptor from the unit.
In the event of overloading due to a fault, the adaptor is designed
to be fail safe and may stop functioning.
Do not attempt to employ H
purposes. Use only on the H
Avoid use in dusty or contaminated environments.
Communications &
USKY
AC Adaptors for alternative
USKY
equipment to which they apply.
USKY
USKY