Replacing The Battery - Husky MP2500 User Manual

THE BATTERY
The MP2500 is designed for use with a alkaline
batteries or a H
USKY
you are using rechargeable batteries, use only the
H MP2500 battery pack.
USKY
Non-rechargeable alkaline batteries are not
generally recommended for use with an MP2500
with peripheral loads. Alkaline batteries are not
suited to low temperature operation.
With a full charge, the MP2500 battery is designed
to last more than a working shift. However, if power
does run low, a warning BATTERY LEVEL LOW will
be displayed. (After a further period of use, your
MP2500 will turn itself off and will not turn on again.)
You should do one of the following:
Return the MP2500 to your base or office
Or recharge the battery (see Charging the
battery)
Or fit a fully charged battery pack (see Replacing
the battery)
Or fit three new AA size alkaline batteries.

Replacing the battery

Turn off the MP2500.
Remove the battery cap by using a suitable coin.
Do not allow rain or moisture into the battery
compartment.
Tilt the unit to slide out the individual cells or
battery pack.
Either: Slide the replacement H
battery pack into the battery compartment,
positive end first.
Or: Fit three new Alkaline batteries, positive
end first. Ensure that all three cells are new and
of the same type, and not partially discharged.
Refit the battery cap. Seat it with finger pressure
first and make sure that it has engaged the screw
threads before tightening it with a suitable coin.
Turn on the MP2500 and check operation.
If you can't turn on, you may need to reset the
MP2500 as described in the CONTROLS section.
rechargeable battery pack. If
MP2500
USKY