Display; Electrical Connection; First Use; Switch On-Off - Electrolux ACN1154 User Manual

For optimum operation and in order to
avoid damage when the lid is opened,
leave a space of at least 5 cm from the
rear wall and 5 cm at the sides.
Before connecting the freezer to the
power supply, ensure that the voltage
corresponds to that indicated in
chapter "Technical
"Voltage".
Danger!
Ensure that the freezer is not resting
on the power supply cable.
Do not remove the power supply cable
by pulling on its lead, particularly when
the freezer is being pulled out of its
niche.
The power supply cable may only be
replaced by a qualified service
personel.
Ensure that the power plug is not
squashed or damaged by the back of
the freezer.
There must be adequate ventilation
around the appliance.
Any electrical work required to install
this appliance should be carried out
by a qualified electrician.
Warning! This appliance must be
earthed.
data" under

First use

Before first use, the freezer should be
cleaned inside, see chapter "Care and
cleaning".
Plug in the appliance.
The green light will come on.
The red light will also switch on since
the temperature inside the freezer is
not yet sufficiently low for food
storage.
The red light will normally switch off
after several hours.
Only place food inside the freezer
once the red light has switched off.

Switch on-off

Switch on the freezer
Turn the thermostat knob to a postion
between and
" "
Switch off the freezer
Turn the thermostat knob to the
position.
electrolux 5
EN
.
" "
OFF