Cooling System; Winter Use; Heated Handles - Husqvarna 61 268 272XP Operator's Manual

Chain saw
Hide thumbs Also See for 61 268 272XP:
Table of Contents

Advertisement

Cooling system

To keep the working temperature as low as possible the
machine is equipped with a cooling system.
The cooling system consists of:
1 Air intake on the starter.
2 Air guide plate.
3 Fins on the flywheel.
4 Cooling fins on the cylinder.
5 Cylinder cover (directs cold air over the cylinder).
5
4
3
2
1
Clean the cooling system with a brush once a week, more
often in demanding conditions. A dirty or blocked cooling
system results in the machine overheating which causes
damage to the piston and cylinder.

Winter use

Running problems can occur when using the machine in the
cold and snowy conditions caused by:
Too low engine temperature.
Icing of the air filter and carburettor.
Special measures are therefore often required:
Partly mask the air inlet on the starter to increase the
working temperature of the engine.
Preheat the intake air to the carburettor by using the heat
from the cylinder.
Temperature 0° ° ° ° C or colder:
Break out the hole or remove the rubber plug so that
preheated air from the cylinder can enter the carburettor
chamber and prevent the air filter from icing up.
MAINTENANCE
Temperature -5° ° ° ° C or colder:
If the chain saw is to be used in cold weather or powder snow
conditions a special cover can be fitted to the starter unit. This
restricts the flow of cooling air and prevents large amounts of
snow from being sucked in.
IMPORTANT! If the temperature rises above -5°C or 0°C
respectively the machine MUST be restored to its normal
set-up. Otherwise there is a risk of overheating, which can
cause severe engine damage.
IMPORTANT! Any maintenance other than that described in
this manual must be carried out by your servicing dealer
(retailer).

Heated handles

272XPG
On models with the model code XPG both the front handle bar
and the rear handle are equipped with electrical heating coils.
These are supplied with electricity from a generator built into
the chain saw. When the red mark on the switch is visible, the
heating is on.
– 35
English

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

268272xp

Table of Contents