Maintenance & Care; Troubleshooting; Warranty Information; Specifications - La Crosse Technology WS-8011UM Instruction Manual

B) MOUNTING WITH SCREWS
1) Remove the mounting bracket from the Remote Temperature Transmitter.
The bracket should snap off easily.
2) Place the mounting bracket over the desired location. Through the three
screw holes of the bracket, mark the mounting surface with a pencil.
3) Where marked, start the screw holes into the mounting surface.
4) Screw mounting bracket onto the mounting surface. Ensure that the screws
are flush with the bracket.
5) Snap the Remote Temperature Transmitter onto the mounted bracket.
C) MOUNTING WITH ADHESIVE TAPE
1) With a nonabrasive solution, clean and dry the back of the mounting bracket
and the mounting surface to ensure a secure hold. The mounting surface
should be smooth and flat.
2) Remove the protective strip from one side of the tape. Adhere the tape to
the designated area on the back of the mounting bracket. Remove the
protective strip from the other side of the tape. Position the Remote
Temperature Transmitter in the desired location, ensuring that the Weather
Temperature Station can receive the signal.
V) MAINTENANCE & CARE

Extreme temperatures, vibrations, and shock should be avoided to prevent
damage to the units.

Clean displays and units with a soft, damp cloth. Do not use solvents or
scouring agents—they may mark and damage the displays and casings.

Do not submerge in water.

Immediately remove all low powered batteries to avoid leakage and damage.
Replace with new batteries only, and of recommended size.

Opening the casings invalidates the warranty. Do not try to repair the units.
Contact La Crosse Technology for Repairs.

TROUBLESHOOTING

Problem: The LCD is faint.
Solution: 1) Replace the batteries.
Problem: "OFL" appears in the indoor temperature LCD.
Solution: 1) Move unit to an area with warmer or cooler surrounding
temperature. Current surrounding temperatures are outside
measuring range.
Problem: No reception of WWVB signal.
Solution: 1) It may help reception to face the front of the Temperature
Clock in the general direction of Ft. Collins, Colorado.
2) Wait overnight for signal.
3) Be sure the Temperature Clock is at least 6 feet from any
11
electrical devices, i.e. TV sets, computers, or other radio
controlled clocks.
4) Remove batteries for five minutes, reinsert and leave the unit
alone overnight without pressing buttons.
5) If problems persist contact La Crosse Technology.
Problem: Hour is incorrect (minute and date are correct).
Solution: 1) Be sure correct time zone and daylight saving time are
selected.
Problem: "--.-" appears in outdoor temperature LCD
Solution: 1) Check batteries in remote
2) If batteries are replaced in remote, the unit must be re-started.
Remove all batteries, and then follow start up procedure.
Problem: "OFL" appears in the outdoor temperature LCD
Solution: 1) Remote temperature is out of range.
2) Check batteries.
3) Interference from an outside source (cordless telephone, etc.)
4) Contact La Crosse Technology.
Note: For any questions not answered, contact La Crosse Technology with the contact
information found at the end of this instructional manual.
SPECIFICATIONS FOR WS-8011UM
Temperature:
Measuring range:
Checking intervals:
Power source:
Battery type:
Battery life:
Dimensions (L x W x H):

WARRANTY INFORMATION

La Crosse Technology provides a 1-year warranty on this Temperature Clock. Contact
La Crosse Technology immediately upon discovery of any defects covered by this
warranty.
Before sending the Temperature Clock in for repairs, contact La Crosse Technology. The
Temperature Clock will be repaired or replaced with the same or similar model.
This warranty does not cover any defects resulting from improper use, unauthorized
repairs, faulty batteries, or the Clocks inability to receive a signal due to any source of
interference.
32F to 122F with 0.2F resolution (indoor)
-21.8F to 140F with 0.2F resolution (outdoor)
(0C to 50C with 0.1C resolution)
Every 10 seconds indoor, 3 times in 10 minutes
for remote temperature.
Station: 2 x AA, 1.5V (Alkaline)
Transmitter: 3 x AAA, 1.5V (Alkaline)
Approximately 12 months
11.4 x 0.98 x 7.5 in (290 x 25 x 190mm)
12