Installation - Parrot MINI KIT Smart User Manual

Installation

Installing the Parrot MINIKIT Smart
Warning: Avoid any installation which could hinder the use of any important command or hinder the
driver's visibility. Do not install the Parrot MINIKIT Smart in the airbag deployment area or in a possible
head impact area. Make sure it is not exposed to the air stream from air vents.
Clean the area with an appropriate cleaning product then mount the craddle on the windscreen. To do
so, press the suction cup against the windscreen and lift the locking lever until the mounting kit is
correctly fixed.
If you want to install the Parrot MINIKIT Smart on your dashboard, first stick the provided circular part on
your dashboard. This support is necessary to affix the suction cup. Once you have stuck the support on
the dashboard, wait for approximately 2 hours to make sure the adhesive tape adheres well.
The cooling and heating cycle inside your vehicle may cause the suction cup to detach from the
windscreen. Make sure the suction cup is properly affixed to the windscreen each time you use the
Parrot MINIKIT Smart. If it is not the case, the device may fall whilst driving. Reinstall the suction cup if
necessary.
Install the Parrot MINIKIT Smart on the mounting kit. Make sure that the Parrot MINIKIT Smart is correctly
secured to the mount by checking the connection on both sides of the magnetic part.
4 Installation