Table of Contents
Advertisement
6
SET-UP AND SAFETY ____________________________________
Wall mounting
The plasma television may only be fixed to vertical walls.
The wall surface must be strong enough to bear the weight.
Use fastening equipment suitable for the weight of the device.
(PlanaVision 42: approx. 35 kg, PlanaVision 50: approx. 53 kg).
For wooden or cavity walls, use suitable wall plugs and screws.
1
Place the plasma screen on a level surface (such as a table), and protect the
screen from scratches.
2
Undo the screws of the device feet (
take off the feet (
Note
Do no remove the spacers attached to the back of the device at the factory
(they protect against overheating).
A
3
Mark the holes on the wall.
– The distance between the screw hooks must be 540 mm.
4
Drill the holes in the wall, insert the wall plugs and screw in the screw hooks.
5
Hang the plasma screen on the screw hooks.
B
). Then tighten the screws again.
A
B
B
A
A
) using the torx driver supplied and
540
Advertisement
Table of Contents
