Advertisement
PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing,
call Customer Service at 1-800-345-4109
or visit our Internet website, www.gracobaby.com.
THIS PRODUCT REQUIRES ADULT ASSEMBLY
Frame
Rear axle assembly
Retainer
Cap
(2, 1 extra)
(2, 1 extra)
Rear wheel (2)
Child's tray
Parent's tray
Front wheel
(on certain models—
assembly (2)
screwdriver required
for assembly)
To Unpack Stroller
Step 1.
Flatten stroller carton to protect floor.
Locking
Step 2.
latch
Open stroller on carton
until locking latches on
both sides are locked
as shown.
Step 3.
Push down on the footrest
until it snaps onto the bar
under it.
785-7-00
5
To Assemble Front Wheels
To prevent
serious injury or death
from choking, remove and
IMMEDIATELY discard plastic
end caps on the front leg pins.
.
Step 1.
Line up pin with a wheel
assembly as shown. Plastic snap
inside wheel mount must be
away from pin.
Step 2.
Push wheel assembly onto pin
until it snaps into place.
Step 3.
Repeat for other wheel assembly.
Pull firmly on each wheel assembly to be sure the
wheel assemblies are securely attached.
To Assemble Rear Axle
Remove
end caps
Rear legs
To prevent serious injury or death from
choking, remove and immediately discard the plastic
covers on the axle.
Step 1.
Turn stroller over as pictured above.
Step 2.
Position rear axle assembly as shown.
Step 3.
Push both brackets on until plastic tabs snap into the slots
on the legs.
Pull firmly on each bracket to be sure the brackets are
securely attached.
6
To Assemble Rear Wheels
Place one rear wheel, red retainer, and white cap on one end
of rear axle in order as shown below. Push red retainer onto
End cap
axle BEFORE attaching white cap. Repeat on other side.
Spokes
toward
inside
Plastic
snap
Rear
axle
Snap red retainer into axle
groove. Then snap cap
over red retainer as shown.
Be sure cap is snapped securely over red retainer.
Brake levers
point toward
you
To Unfold Stroller
Step 1.
Release storage latch and
begin opening stroller.
Step 2.
Continue unfolding until both
latches lock.
To Secure Your Child
sliding out. Always use seat belt.
Step 1.
Wheel
Place crotch strap between
legs and fasten both belt
Cap (white)
buckles together.
Attach AFTER
retainer is on axle
Step 2.
Adjust belt at both buckles as needed to get a snug fit
around your child.
Retainer (red)
Wide end
Step 3.
toward wheel
Squeeze sides of buckles to
release.
To Use Brakes
stroller.
Push DOWN to park.
Check to make sure brake
is on by pushing the stroller.
Lift brake levers UP to stroll.
To Use Head Supports
To use stroller with a smaller
child, pull the plastic pieces
from pockets located in the
back of the cloth seat pad,
and reinsert them with curved
side toward the front.
To use stroller with a larger
child that does not need
head support, insert the plastic
pieces with the curved side
toward the back.
7
Avoid serious injury from falling or
Always apply brakes when parking
Back of cloth seat pad
8
Advertisement
