Yamaha YZF-R1 2000 Supplementary Service Manual page 64

Tachometer
INSTRUMENT FUNCTIONS
Clock mode
To change the display to the clock mode, push
the "SELECT" button for at least one second.
To change the display back to the odometer
modes, push the "SELECT" button.
To set the clock:
1. Push the "SELECT" button and "RESET"
button together for at least two seconds.
2. When the hour digits start flashing, push the
"RESET" button to set the hours.
3. Push the "SELECT" button, and the minute
digits will start flashing.
4. Push the "RESET" button to set the minutes.
5. Push the "SELECT" button and then release
it to start the clock.
The electric tachometer allows the rider to moni-
tor the engine speed and keep it within the ideal
power range.
CAUTION:
Do not operate the engine in the tachometer
red zone.
Red zone: 11,750 r/min and above
Self-diagnosis devices
This model is equipped with a self-diagnosis de-
vice for the following electrical circuits:
S Throttle position sensor
S Speed sensor
S EXUP system
If any of those circuits are defective, the
tachometer will repeatedly display the following
error code:
0 r / min
for
3 seconds
–56–
ELEC
Circuit-specific
Current
number of r / min
engine
for 2.5 seconds
speed for
(See the table
3 seconds
below.)