Yamaha YZF-R1 2000 Supplementary Service Manual page 40

I' Fasten the main harness with a plastic clamp. In-
sert the plastic clamp into the hole on the frame.
J' Route the charcoal canister hose under the engine
air vent hose, coolant reservoir tank breather hose
and all of leads. (California only)
K' Fasten the wire harness with a plastic clamp and
then insert the clamp into the frame.
L' To the radiator fan motor.
M' Route the main harness and fan motor lead into the
hole on the air intake guide. Fasten the main har-
ness and fan motor lead with a plastic clamp.
N' Route the band end to inside. The clamp position
CABLE ROUTING
should be not exceed just behind 30 mm of all coupler.
O' 0 X 30 mm
P' Although the main switch lead couplers and the han-
dlebar switch lead couplers are the same in shape,
they differ in color (the former is white, and the latter,
blue). Connect the couplers of the same color.
Q' Direct the ignition coil leads upward and insert
them into position at the rubber damper.
R' 90_
S' Route the battery negative lead inside the main
harness.
T' Route the battery positive lead upper the main harness.
–32–
SPEC