Yamaha YZF-R1 2000 Supplementary Service Manual page 38

L Fasten the fuel pump lead, speed sensor lead,
neutral switch lead, rear brake light lead, fuel send-
er lead, starter motor lead and EXUP cable with a
plastic clamp.
M 125 mm (4.88 in)
N 50 mm (1.95 in)
O To the fuel cock.
P To the fuel sender.
Q Insert the fuel tank over flow hose into a front side
nipple of fuel tank.
R Insert the fuel tank breather hose into a back side
nipple of fuel tank. The fuel tank nipple and the fuel
CABLE ROUTING
tank breather hose have each white mark.
S 30 mm (1.17 in)
T Fasten the battery positive lead and starter motor
lead with a plastic locking tie.
U Route the rear flasher light lead in the hole on the
rear fender.
V Insert the tail / brake light lead and turn signal leads
under the tail / brake light.
W Fasten the rear flasher light lead and taillight lead
with a plastic clamp. Route the rear flasher light
lead and taillight lead in the hole on the taillight
bracket.
–30–
SPEC