Keyboard Stand Assembly - Yamaha Arius YDP-S31 Owner's Manual

Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Have a phillips-head (+) screwdriver of the
appropriate size ready.
Remove all parts from the box. Confirm that all parts shown in the illustration are provided.
D
1
Attach B to C.
1-1 Set B onto C with the black rim of the
indentation on B facing front.
1-2 Thread the thin screws (5 x 20 mm) through
the spacers, then temporarily secure B and C
from the rear using these screws.
B
* This illustration shows the view from the rear of B
and C.
34 YDP-S31 Owner's Manual
A
B
C
* The adaptor may not be included, or may look different from the illustration above,
depending on your particular area. Please check with your Yamaha dealer.
B
C
C
AC Power Adaptor* x 1
6 x 30mm long screws x 4
6 x 20mm short screws x 4
E
Anti-fall brackets* x 2
2
Attach B to D and E.
2-1 Align D and E with each end of B.
2-2 Attach D and E to B by tightening the long
screws (6 x 30 mm) securely.
D
5 x 20mm thin screws x 2
Spacers x 2
Cord holders x 5
* The two anti-fall brackets are
identical. (Either one can be
used for left or right.)
1
B
2
E