Hand 0-Position Check And Correction; 0-Position Check; 0-Position Correction - Citizen E86 Installation Instructions Manual

Table of Contents

Enlarged version

9. Hand 0-Position Check and Correction

Before using this watch, check that the functions of the watch operate properly by

performing the following procedure.

0-Position: This refers to the base position of each hand for enabling this

watch to function properly.

(1)

1. Turn the crown to switch the watch to the

chronograph [CHR] mode.

2. Pull the crown out to Position 1 to switch

the watch to the 0-position correction

mode. The 24 hour hand, hour hand,

minute hand, second hand and function

hand rapidly advance. Check that each

hand indicates the 0-position.

0 Positions of Each Hand (Base Position)

24 hour hand : 24:00

Hour hand, minute hand : 00:00

Second hand : 00 seconds

Function hand : 0-position (12:00 position)

Perform the "0-Position Correction" procedure when the hands are not at the

positions indicated above.

[0-Position Correction]

0-Position Correction of Function Hand:

1. Pull the crown out to Position 1 in the chronograph [CHR] mode to correct the

function hand.

(1) Press button (A) to align the function hand at the 0-position immediately

after the date has changed (12:00 position).

• Pressing button (A) advances the function hand by one second each time it

is pressed. Continuously pressing button (A) causes the function hand to

advance continuously.

• The date changes by one day when the function hand completes four

revolutions.

Table of Contents