Planet Mobility GB-106 P3 Cruiser Owner's Manual page 24

P3 Cruiser Owner's Manual- Model GB-106
Wheels and Tires
Your P3 Cruiser scooter is equipped with "split-rim" wheels and foam-filled tires.
How to change a tire assembly:
1. Remove the center nut.
2. Remove the tire assembly from the scooter
3. Install a new tire assembly onto the axle.
4. Install and tighten the center nut.
NOTE: All tires on your P3 Cruiser are foam-filled. This means that there is NO air in any
tire. The tires are filled with foam. This means you will never have a flat tire even if you
puncture the tire.
IF YOUR P3 CRUISER DOES NOT OPERATE
• Make certain that the brake handle is set to the engaged (forward) position.
• Check the main circuit breaker. If necessary, reset the circuit breaker.
• Make certain that the speed adjustment dial is at the desired setting.
• Be sure that the key is all the way in the key receptacle and the scooter is "ON"
(note the green "LED" light is illuminated)
WARNING - ONLY START DRIVING IF EVERYTHING IS IN WORKING ORDER! HAVE ANY
!
AND ALL DEFECTS REPAIRED IMMEDIATELY!
IF NONE OF THE ABOVE PROCEDURES SOLVE THE PROBLEM, CONTACT PLANET MOBILITY.
LUBRICATION All of the bearings on your Planet Mobility P3 Cruiser are permanently lubricated
and sealed. No lubrication is required.
GENERAL CARE AND MAINTENANCE
Front Tire
Foam-filled
Page 23
Rear Tire
Foam-filled