Table of Contents
Advertisement
• Continue programming the text as described.
• Conclude programming by pressing the SUB-TOTAL
key.
5.18 Programming the end lines(e.g. entering your gSt#)
The end lines on the receipt can contain up to 3 lines and a maximum of 32 characters per line.
Three end lines are already pre-programmed.
• If you do not want to print end lines, you can delete the pre-programmed end lines.
• Refer to Chapter 5.2 for information on entering text.
• Text lines which are not programmed are not printed.
• Set the key to PRG
OFF
• Select program number 32
REG
• Confirm by pressing CASH
X
Z
PRG
The programmed end lines appear in the display. The end
line is already selected.
For further details, refer to Chapter 5.17.
5.19 Selecting a graphical logo
You can print a graphical logo above the logo message on a receipt.
There are 23 motifs available for selection, refer to Figure 1.
• Set the key to PRG
OFF
• Select program number 44 (refer to Chapter 5.1.2).
REG
• Confirm by pressing CASH
X
The factory default setting is preset to 0. e.g.no graphical
Z
logo is printed.
PRG
• Enter the number of the graphical logo you want to
print in the input area, e.g Figure 17
• Confirm by pressing CASH .
• Conclude programming by pressing the SUB-TOTAL
key.
CLR
etc.
SUB-TOTAL
Input
3
2
CASH
W X Y Z
T U V
Input
4
4
CASH
G H I
G H I
1
7
CASH
P Q R S
@
SUB-TOTAL
35
RCR-75CA
Display
=AD MEASSAGE
- 1=
********************************
THANK
********************************
Display
=GRAPHIC LOGO
- 1=
[0]
STATUS
Advertisement
Table of Contents
