Installation Instructions - Electrolux EBC GL9(S) Instructions For Use Manual

Installation Instructions

Details see safety instructions page C
Electrical connection / supply
Connection by means of a power socket shall be provided by the customer, so that the power socket is available and outside the range of coordination
1. Clamp connection as per the connection diagram
2. Secure the strain relief
The electro connection has to be carried out by a licensed fitter
For a network connecting line, use line version H05VV-F or higher
Installation has to be carried out using a supply line with plug or it shall be provided with a separator laid in the home installation with at
least 3 mm contact gap, which separates the equipment at the same time and all-pin, according to NIN 2000.
Installation
Place the appliance in front of the
1
recess and connect the mains plug
- Cable length: 1.50 m from appliance
- Plug: version 12
Variants
If the compact oven is built in directly over the installation oven in combinations, this must be done with the enclosed support
bracket set no. 315 68 3900. Look at installation sheet no. 315 6837 00 for the installation standard.
When installing several appliances only one recess is necessary. The support brackets are available as optional extras.
EBC GL9 (S)
(55 cm, 230 V)
During installation in combustible matter, NIN 2000, section 4.2.2 and fire protection guidelines and
regulations of the Association of Cantonal Fire Insurance shall be strictly adhered to.
Push the oven into the recess
2
CAUTION: Do not pen in the cable!
When connected to the mains, secure
cable into the cable routing on the left
hand side.
cable
routing
For servicing the appliance must be disconnected!
Fix the oven on the both sides with
3
2 screws (detail A)
EBC GL90 (S)
(60 cm, 230 V)
cable
routing
A
P a g e