Table of Contents
Advertisement
ENGLISH
Playback
Symbols used to indicate buttons in this manual
Button located on both the main unit
and the remote control unit
Button only on the main unit
Button only on the remote control unit
<PURE DIRECT>
DISC LAYER
Disc tray
<ON/STANDBY / OFF>
[CD POWER]
DISC LAYER
[NUMBER]
(0~9, +10)
[TIME]
1/3
[DIMMER]
8
Preparations
BUTTON
Setting the top priority playback layer
<BUTTON>
for Super Audio CDs
[BUTTON]
•
The layer that is played with priority when the disc is loaded can
8, 9
be set.
•
Upon purchase, the priority layer is set to the "STEREO".
1/3
2
1
Turn the DCD-2010AE power on.
<ON/STANDBY / OFF>
(Press
2
Check that no disc is loaded.
b If the layer is switched while the disc is being loaded, the playback
layer switches for that disc, but the top priority playback layer
setting itself does not change.
3
SOURCE
SOURCE
Press
"DISC".
4
DISC LAYER
Press
to set (Super Audio CD only).
SOURCE
[Selectable items]
STEREO
MULTI
[PLAY SELECT]
[REPEAT]
CD
8, 9
b When a disc is loaded after the setting has been made, the
[6, 7]
contents recorded on the set layer are displayed.
2
b If a disc that does not contain the layer set for top priority playback
is loaded, the contents recorded on another layer are displayed
automatically.
b This setting is stored in the memory and is not cleared even when
the disc holder is opened or closed or the power is turned off. To
change the setting, repeat the procedure above.
.)
to set the playback media mode to
and switch to the layer you want
STEREO
MULTI
CD
: Plays back the 2-channel area of the Super Audio
CD (the default setting).
: Plays back the multi-channel area of the Super
Audio CD. The analog output of the DCD-2010AE
outputs a down-mixed 2-channel signal.
: Plays back the CD layer of the Super Audio CD.
•
The priority playback layer cannot be set when a disc is inserted or
"OPEN" is shown on the display.
•
During playback of the multi-channel area, the analog output of the
DCD-2010AE plays back a 2-channel downmix.
•
If the area and layer have not been set for a disc, the priority playback
order is as follows:
q STEREO
w MULTI e CD
•
This setting is memorized by the DCD-2010AE and is retained even
if the disc tray is opened/closed or the power is switched on/off.
Please reconfi gure the settings if you wish to change them.
NOTE
Do not place any foreign objects in the disc tray. Doing so could
damage it.
Before Playing a USB or an iPod
1
Turn the DCD-2010AE power on.
<ON/STANDBY / OFF>
(Press
.)
2
Connect USB memory device or iPod connection
cable.
• When the USB memory device or iPod is connected to the
USB port on the DCD-2010AE, the source media mode
automatically switches to "USB" and fi le playback begins.
The playback media mode setting remains in the memory, even when
the power is set to standby.
n Setting the power to the standby mode
[CD POWER]
Press
.
n Canceling the standby mode
[CD POWER]
Press
again.
n Turning the power off
<ON/STANDBY / OFF>
Press
.
NOTE
• Be sure to stop playback before turning the power off.
• Make sure that the disc tray is completely shut before turning off
the power.
Advertisement
Table of Contents
