Unpacking The Gwh 715 Es Heater - Bosch GWH 715 ES Installation Instructions Manual

Temperature modulated with electronic ignition suitable for heating potable water only - not approved for space heating purposes (intended for variable flow applications)
Hide thumbs Also See for GWH 715 ES:
Table of Contents

Advertisement

Combustion
• NOx ≤ 55 ppm
• CO ≤ 190 ppm
• CO
level set from factory, see chapter 6.4, page 30.
2
Dimensions
• Depth (in): 11¼" (286 mm)
7
• Width (in): 17
" (452 mm)
/
8
• Height (in): 30½" (775 mm)
• Weight: 67 pounds (30.5 kg).
Gas types
Natural Gas.
LP Gas.
Voltage
120 V AC (60 Hz) nominal
Amperage
Idle - 40 mA
Operation - ≤ 2.5 A
Noise
45 - 65 db (A)
Safety devices
• Flame failure device (ionization flame rod sensor)
• Pressure relief valve (supplied with heater)
• Over heat prevention (temperature limiter)
• Inlet temperature sensor
• Outlet temperature sensor
• Back flow temperature sensor.
Water protection
IP X4 (protection against water drops)
If appliance is installed at elevations
i
between
2000ft
combustion gas analyzer is required for
proper calibration of appliance. (see page
24).
6 720 608 158
and
4500ft,
a
2.3

Unpacking the GWH 715 ES heater

Before installing the unit, be certain you have the
correct heater for your type of Gas: Propane or
Natural Gas. Identification labels are found on the
shipping box, and on the rating plate which is located on
the right side panel of the cover.
Fig. 2
Rating plate
A
Serial number
B
Type of gas
The box includes:
• GWH 715 ES
• Pressure relief valve (150 psi / 200,000 Btu rating)
• Bracket for wall hanging the heater
• Exhaust vent adaptor (with 4 screws and gasket
provided)
• Combustion air inlet adaptor (with 3 screws and gas-
ket provided)
• Installation manual (manual can be downloaded at
www.boschpro.com)
• Product registration card
• Energy Guide label.
Please complete and return the enclosed product
registration card.
The GWH 715 ES is not approved or designed for:
• Manufactured (mobile) homes, boats or any
mobile installation.
• Use above 4500ft A.S.L. altitude.
• Outdoor installation without installation of
Outdoor kit (PTOK).
• Applications where inlet water temperature is
higher than 140ºF (60°C).
mixing valve must be installed before the
appliance if inlet water temperature exceeds
this limit.
• Space heating purposes.
Appliance details
A 3-way valve or
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Protankless gwh 715 ctdr efs

Table of Contents