DSC POWER 608 Instruction Manual page 10

PC5508Z LED Keypad
PC5516(Z) LED Keypad
The PC5516, PC5516Z, PC5532 and PC5532Z Keypads are available for applications with more than
8 zones. The functions explained in this manual are the same for all three LED keypad types.
8
Memory Light
Upon disarming, if an alarm has occurred while the
system was armed, the Memory light will turn ON
(See "Disarming the System" on page 6).
Bypass Light
If the Bypass light is ON, one or more zones are
bypassed (See "Zone Bypassing" on page 11).
Fire Light
If the Fire light is ON, a fire alarm has occurred (See
"Fire Alarm Operation" on page 14).
Program Light
The Program light will flash when you are
programming access codes, or performing other
programming functions. If someone is programming
at another keypad, the Program light will turn ON to
indicate that the system is busy.
PC5532(Z) LED Keypad
LCD5500Z Keypad
Display Lights (All Keypads)
Ready Light
If the Ready light is ON, the system is ready for arming.
The system cannot be armed unless the Ready light is
ON (see "Arming the System" on page 4).
Armed Light
If the Armed light is ON, the system has been
armed successfully.
Trouble or System Light
If the Trouble light is ON, see "Viewing Trouble
Conditions" on page 11.
Important Note: Test system weekly and have any system trouble conditions
corrected by your alarm installer.
The Liquid Crystal Display (LCD) displays prompts
and system information on two 16 character lines.
If "< >" appears, more information can be accessed
by using the arrow (< >) keys. Press [<] to see the
previous function or item of information. Press [>] to
advance the display to next function or item of
information.
Press the keys on the number pad as prompted by
the LCD display to view alarms or troubles, to arm and
disarm the system and to bypass zones.
To exit a function and return to the Ready state, press
[#].
To select a function press [ ].
Emergency Keys (All Keypads)
Press both * Keys for two seconds to send a
FIRE transmission.
Press both * Keys for two seconds to send an
AUXILIARY transmission.
Press both * Keys for two seconds to send a
PANIC transmission.
* IMPORTANT NOTE (All Keypads): The Fire,
Auxiliary and Panic keys will NOT function
unless programmed by the installer. If these
keys are in service and the installer has enabled
audible feedback, holding down the key for two
seconds will cause the keypad sounder to beep
indicating that the input has been accepted and
transmission is underway.
9