Electrolux EKV 5605 X Instruction Book page 13

LED timer with time control
The operation of this timer is done via 3 buttons.
The functions of the buttons are:
, Time setting knobs
Mode button
With this arrangement it is possible to select the
following four functions:
Operation period
Operation stop
Minute minder
Time-of-day
Time of day
When connected to mains supply the display
shows 12.00 o'clock and the LED
long as it is flashing, it is possible to adjust the
time via the plus and minus
Once the time is adjusted it is stored approx. 5
seconds after the last operation, the LED
goes dark again.
It is possible to adjust the time-of-day any time it
is required. To do this, press the mode button
until flashes, then the time-of-day can be
adjusted.
Minute minder (interval time)
In order to set the interval time, the "Mode"
button has to be pressed repeatedly until LED
is flashing. Then the interval time can be set
by using the plus and minus buttons. After
setting the interval time, it remains displayed
and the LED , which was flashing before, is
now illuminated steadily. After the interval time
has run down, the alarm signal sounds (2
beeps) and the LED
Pressing any of the buttons stops the signal and
the flashing, the LED goes dark and the display
reverts to the time-of-day.
Operation period
In order to set an operation period, the mode
button has to be pressed repeatedly until the
LED is flashing. Then the desired operation
period (time frame between 0.01h and 10.00h)
can be set using the plus and minus buttons.
Once adjusted, it will be stored after approx. 5
seconds, and the LED
steadily. The display reverts to the time-of-day.
As soon as the operation period has run down,
the relay opens and the alarm signal sounds (4
beeps) and the LED
Pressing any of the buttons stops the signal and
the flashing, the LED goes dark and the relay
closes again.
flashes. As
button.
is flashing again.
remains illuminated
is flashing again.
13