Electrical Connection - Bosch DHI 635 H Operating And Installation Manual

Prior to installation
Exhaust flows straight out at the
back:
– inside the wall cupboard –.
Cut a hole in the rear panel of the wall
cupboard, including a groove for the
mains cable.
Connecting the l 100 mm
exhaust-air pipe:
Cut out the protective grid in the air
outlet.
Attach the reducing connector (enclosed
or can be obtained from specialist
retailers) to the air outlet.
Connecting the l 120 mm
exhaust-air pipe:
Cut out the protective grid in the air
outlet.
Circulating-air mode
With activated carbon filter if exhaust-air
mode is not possible.
The complete
installation set can
be obtained from
specialist outlets.
The corresponding
accessory numbers
can be found at the
end of these opera-
ting instructions.
12

Electrical connection

This is what you have to do:
1. Connect the green and yellow (Earth)
2. Connect the blue (Neutral) wire to the
3. Connect the brown (Live) wire to the
The extractor hood may only be
connected to an earthed socket that has
been installed according to the relevant
regulations. If possible, site the earthed
socket directly above the wall cupboard or
in its immediate vicinity.
Electrical data:
Are to be found on the name plate inside
the appliance after removal of the filter
frame.
always disconnect the extractor hood from
the electricity supply.
Length of the connecting cable: 1.30 m.
If it is necessary to wire the extractor
hood directly into the mains:
The extractor hood should only be
connected to the electricity supply by a
properly qualified electrician.
A separator must be installed in the
household circuit. A suitable separator is a
switch that has a contact gap of more than
3 mm and interrupts all poles. Such
devices include circuit breakers and
contactors.
This extractor hood corresponds to EC
O
regulations concerning RF interference
100
suppression.
120
wire to the terminal in the plug marked
'E' or with the symbol (
coloured green or green and yellow.
terminal in the plug marked 'N' or
coloured black.
terminal marked 'L', or coloured red.
Before undertaking any repairs,
), or