Table of Contents
Advertisement
Setting up and connection instructions
Technical Data /Dimensions
Height adjustment
Approx. +10/-5mm
Filling quantity
max. 5kg
(program-dependent)
Use
Domestic
Drum speed, spin
see rating plate
Water pressure
1-10bar
(=10–100N/cm
Safety Instructions for Installation
• Do not tilt the washing machine onto its front or
onto its right side (looking from the front). Electri-
cal components could get wet!
• Check the washing machine for transport dam-
age. Never connect a damaged unit. Consult your
supplier in the event of damage.
• Ensure that all parts of the transport safeguard
have been removed and that the splash guard is
fitted to the unit, see "Removing the Transport
Safeguard". Otherwise, damage to the unit or to
adjacent furniture could occur during spinning.
• Always insert the plug into a correctly installed PE
socket.
• In the case of permanent installation: A perma-
nent installation may only be made by an author-
ised specialist.
• Before putting the unit into operation, ensure that
the rated voltage and current type shown on the
unit's rating plate are the same as the mains volt-
age and current type at the installation location.
The required electrical fuse is also shown on the
rating plate.
• Should work be carried out on the water supply
installations in order to allow the machine to be
connected properly to the water supply, this work
must be carried out by an authorised installer.
• Should work be carried out on the mains supply
in order to allow the machine to be connected
properly to the electricity supply, this work must
be carried out by an authorised electrician.
2
= 0.1–1.0MPa)
• The mains cable may only be replaced by the
Customer Service or by an authorised specialist.
(dimensions in mm)
35
Advertisement
Table of Contents
