What To Do If; Remedying Small Malfunctions - AEG FAVORIT 35080 i User Information

What to do if...

Remedying small malfunctions

If while the appliance is operating indicators on the control panel flash
or are lit up as described in the following table, please consult this to
find out how to remedy the fault.
After remedying the fault that is flashing in the first or second
rhythm in the programme progress display, press the start-button. The
cycle will continue.
In the case of other fault messages:
– Cancel the dishwashing cycle.
– Switch the appliance off and on again.
– Select dishwashing cycle.
If the fault is displayed again, please contact the Customer Care De-
partment and inform them of the fault message.
Malfunction
The indicator for the end of
the dishwashing cycle is
flashing in rhythm 1 short
light signal with approx. 3
second pause in-between:
(Problems with water inlet)
The indicator for the end of
the dishwashing cycle is
flashing in rhythm 2 short
light signals one after anoth-
er. (there is water in the
dishwasher's internal tank).
24
Possible cause
The tap is blocked or furred
with limescale.
The tap is turned off.
The filter (where present) in
the threaded hose fitting on
the tap is blocked.
Filters in the base of the
washing compartment are
blocked.
Water inlet hose
has not been correctly posi-
tioned.
The spigot is blocked.
Water drain hose
has not been correctly posi-
tioned.
Remedy
Clean tap.
Turn on the tap.
Clean the filter in the
threaded hose fitting.
Cancel the dishwashing
cycle (see section:
Starting a dishwashing
cycle);
clean filters (see section:
Cleaning the filters).
Check hose installation.
Clean the spigot.
Check hose installation.