Prior To Using For The First Time; Setting The Water Softener - AEG FAVORIT 35080 i User Information

Prior to using for the first time

3
If you wish to use 3 in 1 detergent:
– First read the section "Using 3in1 detergents".
– Do not fill up with special salt or rinse aid.
If you do not use 3in1 detergent, before using for the first time
1. Set the water softener
2. Fill up with special salt for water softeners
3. Fill up with rinse aid

Setting the water softener

The water softener must be set manually and electronically:
3
To avoid scale deposits on the dishes and in the dishwasher, the dishes
must be washed with soft water, i.e. water with a low lime content. The
water softener must be set according to the table to the water hard-
ness in the area where you live. Your local water company will be able
to give you information about the water hardness in your area.
The dishwasher must be switched
off.
Setting manually:
1. Open the dishwasher door.
2. Remove the lower basket from the
dishwasher.
3. Turn water hardness dial on the left
wall of the dishwasher interior to O
or 1 (see table).
Setting electronically:
4. Press and hold Start button.
5. Turn control knob clockwise as far as the first programme.
6. Then release Start button.
– The indicator for the Start button will flash.
– The number of times that the indicator for the end of the dishwash-
ing cycle flashes corresponds to the hardness setting.
– This sequence of flashes is repeated several times, with a 3 second
pause in-between.
7. Pressing the Start button increases the hardness setting by 1.
(Exception: hardness setting 1 follows hardness setting 10).
7