What To Do If - AEG FAVORIT 78002 VI User Manual

WHAT TO DO IF...

The appliance does not start or stops during operation.
If there is a fault, first try to find a solution to the problem yourself. Refer to following
charts. If you cannot find a solution to the problem, contact your dealer or the Customer
Care Centre.
With some malfunctions, the display shows an alarm code:
• - The appliance does not fill with water
• - The appliance does not drain the water
• - The anti-flood device operates.
WARNING!
Switch the appliance off before you do the suggested corrective actions.
Malfunction
The appliance does
not fill with water
The appliance does
not drain the water
The anti-flood device
operates
The program does
not start
After the check, switch on the appliance. The program continues from the point of inter-
ruption. If the malfunction occurs again, contact your Customer Care Centre.
Possible cause
The water tap is closed.
The filter in the water inlet hose is
blocked.
The installation of the water inlet
hose is not correct. The hose is bent
or squashed.
The water tap is blocked or restricted
with limescale.
The water pressure is too low.
There is a blockage in the sink spi-
got.
The installation of the water drain
hose is not correct. The hose is bent
or squashed.
The appliance door is not closed.
Mains plug is not connected.
The delay start is set.
The fuse has blown out in the
household fuse box
What to do if...
Possible solution
Open the water tap.
Clean the filter.
Make sure that the installation is
correct.
Clean the water tap.
Contact your local water authority.
Clean the sink spigot.
Make sure that the installation is
correct.
Close the water tap and contact
your Customer Care Centre.
Close the door.
Plug-in the appliance to the mains.
• Cancel the delay start.
• Wait until the countdown of the
delay start is completed.
Replace the fuse.
21