Electrical Connection; Aligning The Appliance - Bosch KFN91 Series Operating And Installation Manual

de en

Electrical connection

Following the installation of the
appliance, wait at least 8 hours before
starting it up. The oil in the compressor
can shift to the refrigeration system
during transport.
Clean the inside of the appliance
before it is first used (see section
"Cleaning").
The socket must be near to the
appliance and easily accessible, even
after the appliance has been moved
into place.
Connect the appliance to a
220−240 V/50 Hz alternating current
via a properly installed socket with an
earth wire. The socket must have a
10 A − 16 A fuse.
In the case of appliances operated
outside Europe, check whether the
voltage and type of current specified
on the nameplate conform to the
values of your electricity grid. This
information is located on the
nameplate.
Warning!
!
In no circumstances may the
appliance be connected up to an
electronic energy saving socket.
Sine− and line−commutated inverters
can be used with our appliances. In
the case of isolated installations in
holiday homes or on boats, for
example, you must use a
sine−commutated inverter.
6

Aligning the appliance

Information!
So that it functions properly, the
appliance must be set level using a
spirit level.
An improperly aligned appliance can
result in water running out of the ice
maker, ice cubes of different sizes
being made, or the doors not closing
properly.
1. Place appliance at the intended
location.
2. Unscrew the three screws on the
base panel.
3. Remove the base panel.
4. Use an Allen key to screw the two
front feet out until they stand firmly
on the ground and align the
appliance at the front.
5. Use an Allen key to turn the screws
and align the appliance at the rear.
Raise the appliance at the rear:
Turn the screw clockwise.
Lower the appliance at the rear:
Turn the screw anticlockwise.
6. Check for horizontal alignment of
the appliance using a spirit level.
Information!
The front feet must stand firmly on the
ground so that the appliance does not
roll away.
7. If the fridge compartment doors or
freezer drawer have an uneven
height or are on a slant once the
appliance has been aligned, align
them as described below.