Fitting The Base Panel - Bosch KFN91 Series Operating And Installation Manual

de en
3. Position the handles for the fridge
compartment doors on the guides.
4. Slide the handles downwards until
they snap into place.
5. Attach the protective sheets.
6. Place the handle for the freezer
compartment drawer onto the
guides.
7. Slide the handle to the right until it
snaps into place.
8. Remove the protective sheets and
keep them for reuse.
8
Removing the handles
Information!
To avoid scratching the surface, attach
the protective sheet a little below the
handle so that it is not pushed to the
side by the handle.
1. Attach the protective sheets as
follows:
To the fridge compartment doors
n
above the guides.
To the freezer compartment
n
drawer to the left of the guides.
2. Push the handles for the fridge
compartment doors upwards and
remove them.
3. Push the handle for the freezer
compartment drawer to the left and
remove it.
4. Remove the protective sheets and
keep them for reuse.

Fitting the base panel

1. Unscrew the three screws on the
device.
2. Position the base panel.
3. Position and tighten the three
screws.