Bosch KFN91 Series Operating And Installation Manual page 24

de en
Ice and water dispenser
Malfunction
The water filter symbol is
flashing.
The ice maker is not
producing enough ice
cubes or the ice cubes are
a strange shape.
The ice maker is not
producing enough ice
cubes or isn't producing
any at all.
The ice cube container
contains ice cubes but they
are not being dispensed.
The ice maker is not
producing ice cubes.
24
Possible cause
The filter cartridge is worn out.
Following the replacement of the filter
cartridge, the water filter symbol was not
reset.
The appliance or ice maker was only switched
on a short time ago.
A large amount of ice was removed.
Water pressure too low.
The filter cartridge is blocked or worn out.
An ice cube has become stuck in the arm
used to measure the fill level of the ice cube
container.
When switching from ice cubes to crushed
ice, an ice cube might get stuck in the
dispenser opening. The ice cube drips into the
ice and water dispenser.
There is a layer of ice on the feed screw.
The ice cubes have frozen together.
The ice maker is switched off.
The appliance is not being supplied with
water.
There are kinks in the water connection line.
Water pressure too low.
The ice cube container is not inserted
properly.
The water connection is improperly installed.
Remedial action
Replace the filter cartridge.
Reset the water filter symbol.
It takes approx. 24 hours before ice
production begins.
It takes approx. 24 hours, until the ice cube
container is again filled.
Check the water pressure.
Replace the filter cartridge.
Pull out the ice cube container and remove
the stuck ice using a blunt plastic implement.
Do not use pointed or sharp objects, as this
could damage the appliance.
Remove the stuck ice from the dispenser
opening using a blunt plastic implement. Do
not use pointed or sharp objects, as this could
damage the appliance.
Pull out the ice cube container and clean it.
Pull out the ice cube container and clean it.
Switch the ice maker on.
Have a skilled plumber check the water
connection line.
Turn off the water supply. Smooth out the
kinks. Have the damaged water connection
line replaced by an original spare part from the
manufacturer.
Check the water pressure.
Insert the ice cube container properly.
An improper water connection can cause low
water pressure and damage to the appliance.