Attaching The Handles - Bosch KFN91 Series Operating And Installation Manual

Aligning the fridge
compartment door
If the top and bottom edges of the
two fridge compartment doors are
not at the same level, proceed as
follows:
1. Determine which fridge
compartment door needs to be
raised.
2. Use the nut on the lower mount to
align the fridge compartment door.
To raise the fridge compartment
door:
Turn the screw anticlockwise.
To lower the fridge compartment
door:
Turn the screw clockwise.
If the fridge compartment doors are
on a slant, proceed as follows:
Warning!
!
Risk of electric shock!
Before removing the top panel:
interrupt the supply of water to the
appliance. Pull out the mains plug or
disable the fuse.
1. Determine which fridge
compartment door needs to be
adjusted.
2. Unscrew the five screws on the top
panel.
3. Raise the panel.
4. Loosen the screws.
Do not take the screws out!
5. Align the fridge compartment door
by moving the mount to the side.
6. Tighten the screw.
7. Position the panel.
8. Position and tighten the five
screws.
Aligning the freezer
drawer
1. Determine which side needs to be
adjusted.
2. Loosen the two screws.
Do not take the screws out!
3. Align the freezer drawer using the
top screw.
4. Tighten the two screws.

Attaching the handles

Only attach the handles once the
appliance has been positioned in its
installation location and has been
aligned so that it is level.
All of the handles are the same.
There are two protective sheets
enclosed with the appliance for
attaching and removing the handles.
These sheets can be reused.
The protective sheets protect the
surfaces during the attachment and
removal of the handles.
Information!
If the handles are incorrectly
positioned, they cannot be pushed in
the specified direction.
Position the handles properly as
follows:
It must be possible to push the
handles for the fridge compartment
doors downwards.
It must be possible to push the handle
for the freezer compartment drawer to
the right.
If the handles are hard to push,
carefully tap them with a rubber
hammer.
1. Remove the protective sheets from
the fridge compartment doors and
the freezer compartment drawer.
2. Attach the protective sheets.
en de
7