Rear Panel - GoVideo HT2010 User Manual

Rear Panel

VCR IN LINE 1 (AUDIO/VIDEO)
Connect to the audio/video output of an external
source (audio system, TV/monitor, another VCR, etc.).
RF OUT (DVD/VCR OUT)
Connect to a TV with an RF coaxial input.
Connect the VHF/UHF/CATV antenna to
AC Power Cord
Plug into a standard wall outlet.
Connect to a TV with an S-Video Input. FOR DVD VIEWING ONLY.
Select either S-VIDEO OUT or COMPONENT VIDEO OUT, depending on how
Dust Protection Cap
Remove the dust protection cap from the
DIGITAL AUDIO IN jack and connect the
optical digital cable (not supplied) securely
so that the configurations of both the cable
and the connector match. Keep the dust
protection cap and always reattach the cap
when not using the connector to protect
against dust intrusion.
10
ANT.IN
this terminal.
S-VIDEO OUT (DVD OUT)
DIGITAL AUDIO IN (OPTICAL)
Connect to the digital audio output of an external
digital device (see "Dust Protection Cap" below).
you connected the DVD+VCR to your TV.
Connect the FM antenna to this terminal.
DVD/VCR OUT (AUDIO/VIDEO (Left/Right))
Connect to a TV with video and audio inputs.
COMPONENT VIDEO OUT (Y Pb Pr) (DVD OUT)
Connect to a TV with Y Pb Pr inputs. FOR DVD
VIEWING ONLY.
VIDEO OUTPUT Switch
FM Antenna Connectors
AM Antenna Connectors
Connect the AM antenna to this terminal.
Connect the six supplied speakers to these terminals.
Do not touch the inner pins of the jacks on the rear
panel. Electrostatic discharge may cause permanent
damage to the unit.
SPEAKER Connectors