Viewing the Heat Pump and
Reversing Valve Jumper Settings
Steps 10 and 11 are 'Read Only' and may only be set with the
jumpers on the circuit board of the thermostat (see page 4.4 of
the Installation Instructions).
Press SETUP button to
enter Setup screens.
Press the MODE button repeatedly
MODE
until this setup screen appears.
10
ON = Heat Pump
operation
OFF = Gas Electric
operation
Indicates
that
the
thermostat
jumper
is
set
for
an
reversing
valve
(energize in cooling)
or a b reversing valve
(energize in heating).
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Air Conditioning & Heating
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through
setup screens.
Setup
10
HP
OFF
Setup
11
O
O
Page 10.2
MODE
MODE
the
Press
MODE
Press