Honda CRF250X Owner's Manual & Competition Handbook page 53

Owner's manual & competition handbook
Hide thumbs Also See for CRF250X:
Table of Contents

Advertisement

250X_030-059.qxd 08.7.14 14:29 ページ47
Checking & Adding Oil
(3)
(1)
(1) transmission oil filler cap (3) sealing washer
(2) oil check bolt
1. Run the engine at idle for 3 minutes, then shut
it off.
2. Wait 3 minutes after shutting off the engine to
allow the oil to properly distribute itself in the
clutch and transmission.
3. Support the CRF in an upright position on a
level surface.
4. Remove the transmission oil filler cap (1), oil
check bolt (2) and sealing washer (3) from the
right crankcase cover. A small amount of oil
should flow out of the oil check bolt hole.
Allow any excess oil to flow out of the oil
check bolt hole.
If no oil flows out of the oil check bolt hole,
add oil slowly through the transmission oil
filler hole until oil start to flow out of the oil
check bolt hole.
Tighten the oil check bolt with a new sealing
washer and transmission oil filler cap. Repeat
step 1 – 4.
5. After inspection the oil level or adding oil,
tighten the oil check bolt to the specified
torque:
Oil Check Bolt: 12 N·m (1.2 kgf·m, 9 lbf·ft)
6. Install the transmission oil filler cap securely.
Replacing Transmission Oil
1. Run the engine at idle for 3 minutes, then shut
it off.
2. Support the CRF in an upright position on a
level surface.
3. Remove the transmission oil filler cap (1)
(2)
from the right crankcase cover.
4. Place an oil drain pan under the engine to
catch the oil. Then remove the transmission
oil drain bolt (2) and sealing washer (3).
5. After the oil has drained, apply fresh engine
oil to the transmission oil drain bolt threads
and tighten it with a new sealing washer to the
specified torque:
16 N·m (1.6 kgf·m, 12 lbf·ft)
(3)
(1)
(1) transmission oil filler cap
(2) transmission oil drain bolt
(3) sealing washer
Transmission Oil
6. Fill the crankcase with recommended oil.
Capacity: 0.67R(0.71 US qt, 0.59 Imp qt)
after oil change
7. Check the transmission oil level by following
the steps in Checking & Adding Oil (this page).
Pour the drained oil into a suitable container and
dispose of it in an approved manner (page 143).
NOTICE
Improper disposal of drained fluids is harmful to
the environment.
(2)
Servicing Your Honda
47

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents