Charcoal Filter; Changing The Light Bulb - Electrolux EFC 650 Operating And Installation Manual

Charcoal filter

• The charcoal filter should only be used if you
want to use the hood in the recirculation
function.
• To do this you will need an original
ELECTROLUX charcoal filter (available from
your local Service Force Centre).
• This filter cannot be cleaned or reused.
• As a general rule, the activated charcoal
filter should be changed once every four
months.
• Fitting — Fig. 4
Fit one charcoal filter on the left and one on the
right so to cover the plastic grids that protect the
fan wheel, check that the pins R on the
conveyor match with housing S on the charcoal
filter, then turn clockwise to fix it.
• To remove proceed in the reverse order.
• Always specify the hood model code number
and serial number when ordering replacement
filters. This information is shown on the
registration plate located on the inside of the
unit.
• The charcoal filter can be ordered from your
local ELECTROLUX Service Force Centre.

Changing the light bulb

• Disconnect the unit from the mains power
supply.
• Remove the grease filters.
• Replace the old bulb with a new one of the
same type.
• Refit the grease filter.
• If the light does not come on, make sure the
bulb has been inserted in correctly before
contacting the technical assistance service.
R
Fig. 4
37
R
S
S