Table of Contents
Advertisement
10 electrolux
To interrupt a programme which is running,
press the button 6: the corresponding
green pilot light starts blinking.
To restart the programme from the point at
which it was interrupted, press the button 6
again. If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the red pi-
lot light of the button 6 blinks for 3 times
the message Err is displayed for a few sec-
onds.
ALTERING AN OPTION OR A RUNNING
PROGRAMME
It is possible to change some options be-
fore the programme carries them out.
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton 6.
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
and then to the new pro-
gramme position. Start the new programme
by pressing the button 6 again. The wash-
ing water in the tub will be not emptied out.
INTERRUPTING A PROGRAMME
Press the button 6 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to restart the pro-
gramme.
CANCELLING A PROGRAMME
Turn the selector dial to
gramme which is running.
You can select now a new programme.
OPENING THE DOOR
After the programme has started (or during
the delay time) the door is locked. If you
need to open the door, press first the but-
ton 6 to set the machine to PAUSE. After a
few minutes the light 8.2 goes out. It is pos-
sible to open the door.
If this light remains lit and the door is
locked, this means that the machine is al-
Stand by : once the programme has finish-
ed after a few minutes the energy saving
system will be enabled. The brightness of
to cancel a pro-
ready heating or that the water level is too
high. In any case, do not try to force the
door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to
few minutes the door can be opened (pay
attention to the water level and temper-
ature!).
After closing the door, it is necessary to set
the programme and options again. Press
button 6 to start the machine.
AT THE END OF THE PROGRAMME
The machine stops automatically. The dis-
play shows three blinking zeros (
Some acoustic signals sound. The light of
button 6, the lights 8.1 and 8.2 go off.
After some minutes the light 8.3 illuminates.
The door can be opened.
If you have set a programme or an option
that ends with water left in the tub, the light
8.2 remains on. The door is locked. The
water must be emptied out before opening
the door. During this time the drum contin-
ues to rotate at regular intervals.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
.
2. Set the draining or spinning pro-
gramme.
3. If needed reduce the spin speed.
4. Press button 6.
At the end of the programme, the light 8.2
goes off. The door can be now opened.
Turn the programme selector dial to
switch the machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
the display is reduced. By pressing any but-
ton the appliance will come out of the ener-
gy saving status.
. After a
).
to
Advertisement
Table of Contents
