Installation Preparation; Refrigerator Leveling & Door Adjustment (If Needed) - Westinghouse WHE7670SA User Manual

INStALLAtIoN pREpARAtIoN

REMoVING fREEzER dooR
1 Open freezer door as far as possible, pull up freezer
case and freezer drawer
2 Push locks (on both sides) and pull forward Freezer
door and remove
3 Bottom hinges may be required to be removed as well
to get through some door openings
REpLACING REfRIGERAtoR dooRS
– Replace the left door, right door, then replace the top
hinge cover
– Replacing steps are the reveres of the steps of
removing the doors
REpLACING fREEzER dooR
1 Align the end of rails (both sides) with supporter of
freezer drawer rail
2 Fully push and close freezer door, check locking of the
rail with the lock of supporter
3 Open the freezer as far as possible, assemble one
gear rail in supporter of rail gear
4 Push and assemble another gear rail on opposite side
of the rail
REfRIGERAtoR LEVELING & dooR AdjUStMENt
(If NEEdEd.)
The refrigerator must be level in order to maintain optimal
performance and desirable front appearance
(If the floor beneath the refrigerator is uneven, The freezer
and refrigerator doors look unbalanced )
LEVELING ANd dooR AdjUStMENt
Leveling the appliance
1 Remove the front cover, if it is attached
2 Use a hexagonal wrench to align the front of the
appliance
AdjUStING A REfRIGERAtoR dooR
If the height of the refrigerator doors is uneven, turn
the screw nut on the lower hinge to adjust the
refrigerator door
– To raise a refrigerator door turn the screw
counterclockwise
– To lower a refrigerator door turn the screw clockwise
installation 11