Service Menu - CADDX NX-8 User Manual

SERVICE MENU

The service light will be "on" if the security system requires service. If the service
light is "on", press the [ ] key followed by the [ 2 ] key to determine the service
condition. One or more zone lights will illuminate indicating what service(s) is
required. Call your service provider immediately for these problems. Below is a
listing of what each light means in a service condition.
LIGHT
1 SYSTEM FAULT - Press the [ 1 ] key. The zone light(s) that is
illuminated corresponds to the system fault(s) below:
1 Over Current Fault
2 Siren Trouble
3 Box Tamper
4 Expander Power
Note: Faults 1 & 2 are global in nature and will affect all
partitions of a multi-partition system . Press the [ # ] key to return
to the 1 of 8 service lights .
2 ZONE TAMPER - Press the [ 2 ] key and the zone light(s) will illuminate
showing the zone(s) that are tampered. Press the [ # ] key to return to
the 1 of 8 service lights .
3 ZONE LOW BATTERY - Press the [ 3 ] key. The zone light(s) will
illuminate showing which zone(s) has a low battery. This only applies
to wireless zones. Press the [ # ] key to return to the 1 of 8 service
lights .
4 ZONE LOSS OF SUPERVISION - Press the [ 4 ] key and the zone
light(s) will illuminate showing which zone(s) has loss of supervision.
This only applies to wireless zones. Press [ # ] key to return to the 1 of 8
service lights .
5 ZONE TROUBLE - Press the [ 5 ] key and the zone light(s) will
illuminate showing which zone(s) has a trouble condition. Press the [ # ]
key to return to the 1 of 8 service lights .
TELEPHONE FAULT - Press the [6] key. The zone light(s) that is
6
illuminated corresponds to the system fault(s) below:
6
7
FAILURE TO COMMUNICATE - This light will illuminate when there is
7
a failure to communicate between your system and the central station.
LOSS OF SYSTEM TIME - This light will illuminate when there has
8
been a loss of power and your system clock needs to be reset.
Instructions are on page 13.
EXIT Press the [#] key to exit the Service Light mode.
Note: This fault is global in nature and will affect all partitions of a
multi-partition system.
Line Trouble / Line Cut - This light will illuminate when there is
telephone line trouble or the telephone line has been cut. The
service light will remain lit until the telephone trouble clears and
a user code is entered.
Auxiliary Comm Device Fail - Radio backup has failed.
PROBLEM
5 Expander Low Battery
6 Expander Box Tamper
7 Expander Trouble
8 Ground Fault
15