Change Video Setting - American Dynamics VideoEdge Installation & Operation Manual

5.1.2 Change Video Setting

Please follow the steps below to change the image setting through the network as necessary.
1. Click on the Video button on the home page to enter the image-setting page.
Video setting page of MJPEG mode
2. Adjust the image setting including "Device Title", "Resolution", "Quality", "Frame rate"
(MPEG4 mode only), "Format", and "Viewer Type" (MJPEG mode only) , and "MJPEG
Deinterlace" (MJPEG mode only) as necessary.
3. Click on the Submit button to submit the new image setting.
4. Click on the Fine Tune button to enter the Video Fine Tune page to set the details of the
device including: "Brightness", "Saturation" and "Sense Up". Click on the Default button to
reset all the settings.
NOTE: The revised image will appear immediately after any change is made.
32
Video setting page of MPEG4 mode
Installation & Operation Guide