Page 2
® RIVE IGHT TAINLESS TEEL TRAP OUNTING NSTRUCTIONS ® (For use with Heavy-Duty DriveRight Installation Kits) Assembly Parts: • Stainless Steel Cable Tie • Stainless Steel Magnet Mount • Magnet • Neoprene Rubber Strip Tools Required: To assure that sufficient tension is applied to the stainless steel cable tie to prevent slipping of the Magnet Holder Assembly, a tension- ing tool must be used.
Page 3
2. Install the magnet into the holder and slide the stainless steel cable tie into the holder, securing the magnet inside. Note the orientation of the clasp to the holder. 3. Place the neoprene rubber strip around the driveshaft and loosely wrap the stainless steel cable tie over the rubber strip, positioning the magnet holder in the 1.5”...
Page 4
“S ” T QUEEZE ANDLE IGHTENING Slide the installation tool over the stainless steel cable tie as shown and squeeze the handle to apply tension. If the handle is all the way closed and more tension is needed, release the handle and slide the tool towards the clasp. Again squeeze the handle until jthe desired tension has been reached.