Summary of Contents for DAVIS Sensor Tilting Bracket
Page 1
The Sensor Tilting Bracket (STB) enables you to adjust the position of the solar radiation sensor and/or the UV sensor to match the angle of the sun’s rays. Use the STB with the Energy EnviroMonitor™ to match the angle of the solar radiation sensor to the angle of your solar panels.
Consult the sensor manual for the remaining instructions on attaching the sensor to the STB. Page 2 EEDED TTACH ENSOR SING TANDOFFS TO OUNT THE ENSOR Sensor Tilting Bracket...
Page 3
STB arms you use when mounting the bracket. The illustra- tion below shows the orientation of the holes (from 1 to 16). The table below shows the tilt angle achieved by using any given hole. Mounting the Sensor Tilting Bracket ILTING RACKET...
Page 4
The best tilt angle is derived by subtracting declination from latitude. You may then use the table in “The Tilt Angle” on page 3 to determine which hole on the STB arms best matches that angle. Page 4 Sensor Tilting Bracket...
Page 5
3. Make sure you secure the sensor cable below the SMA as shown in the sensor manual. Mounting the Sensor Tilting Bracket ® software for sunrise and sunset times. To correctly align...
Page 6
STB point towards the sun at solar noon. Solar noon occurs halfway between sunrise and sunset; consult your local paper or the WeatherLink Page 6 REPARING OUNTING URFACE ® software for sunrise and sunset times. Sensor Tilting Bracket...
Page 7
For clarity, the sensor is not shown in the drawing below. 4. Secure the sensor cable to the mounting surface using cable clips or weather resistant cable ties with screw holes or other means for mounting. Mounting the Sensor Tilting Bracket OUNTING ON AN LTERNATE...