Advertisement
2. Install the magnet into the holder and slide the stainless steel cable tie into the
holder, securing the magnet inside. Note the orientation of the clasp to the
holder.
3. Place the neoprene rubber strip around the driveshaft and loosely wrap the
stainless steel cable tie over the rubber strip, positioning the magnet holder in
the 1.5" gap (the magnet holder should rest directly on the shaft). Insert the end
of the stainless steel cable tie into the clasp and slowly tighten. Position the
clasp 180˚ from the magnet on the shaft. When everything is properly in position,
tighten the cable tie by hand.
4. Proceed to the tightening instructions for the tightening tool you have.
"S
"
CREWDRIVER
TYPE TIGHTENING TOOL
1. Trim the stainless steel cable tie using cutters or tin snips so that 2" remains
protruding from the clasp.
2. Insert the end of the stainless steel cable tie into the slot at the end of the
tightening tool. Grip the tool by the handle and hold the magnet in place. Slowly
twist the tool to further tighten the cable tie. Rotate the tool so that the tool tip
goes down toward the clasp and under the remaining tie.
3. When the desired amount of tension has been reached and the magnet is
secure, slide the tool out of the center of the coil. Flatten the rolled coil against
the shaft.
Cross section of
the tensioned tie
2
Advertisement
