Storing A Track With Tpm; Cd Reproduction With Tpm; Clearing The Tpm Programme; Scan 1 - Blaupunkt LONDON RDM 43 Operating Instructions Manual

Storing a track with TPM

Insert a CD.
Select the tracks with
indicator C b shows the number of the
selected track.
Press TPM : until a beep is released
or the set resumes play. Then the track
is stored.
Use again the / button to select the
following track and store with TPM, etc, as
described before.
You can memories tracks even if a CD is
played, provided the TPM function is on.
Following these steps you can store the TPM
programmes for another 29 CDs.

CD reproduction with TPM

Insert a CD.
The TPM function must be switched on
(TPM on/off with button :).
The titles programmed with "TPM" will be
played in ascending sequence. The tracks
which have not been stored will be skipped.

Clearing the TPM programme

The CLR button allows you to clear individual
tracks, all tracks of a CD or the entire TPM
memory.
30
For clearing the TPM programmes, TPM
must be switched on.
TPM on/off with button :, see display C l.
F. The
/
a) clearing a TPM track:
Insert the CD.
Switch TPM on with :.
Select the tracks with
Press the CLR button < for about
2 secs. until "CLEAR" is shown in
the display.
This track is cleared from the TPM me-
mory.
b) clearing the TPM memory of a CD:
Insert the CD.
Switch TPM on.
Press the CLR button < for about
8 secs. until "CLR DISC" is shown
in the display.
The TPM memory of this CD is cleared.
c) clearing the TPM memory of all CDs:
Insert the CD.
Switch TPM on.
Press the CLR button < for about
14 secs. until "CLR-TPM" is shown
in the display.
The TPM memory for all the CDs is
cleared.

SCAN 1

This function allows you to scan the CD
tracks for about 10 secs. each one after the
other.
To activate Scan
F.
/
press button 1 for approx. 1 sec.
"CD scan" lights in the display C a. The
following tracks will be scanned successive-
ly for 10 secs. each.
With the TPM function activated (C l lights),
the set only plays the tracks stored in the
TPM memory.
If the scanned track shall be played comple-
tely,
press the SCAN 1 once again. The
scanned track will be played without
interruption.

Mix ;

With activated Mix function, the CD tracks
will be played in an arbitrary order. "Mix" is on
in the display C m.
If TPM is on (C l lights), the set only plays
the tracks stored in the TPM memory.
If you do not like the scanned track, press the
rocker switch
Use the Mix button ; to switch this function
on and off.
F to skip this track.