NordicTrack T5 Lv Treadmill User Manual page 11

8. IMPORTANT: To avoid damaging the Pulse
Crossbar (31), do not use power tools and
do not overtighten the #10 x 3/4" Screws
(13).
Orient the Pulse Crossbar (31) as shown.
Start one #10 x 3/4" Screw (13) with one #10
Star Washer (11) into each end of the Pulse
Crossbar and each of the Handrails (71, 72).
Then, start another #10 x 3/4" Screw and
#10 Star Washer into each end of the Pulse
Crossbar. Start all four Screws, and then
tighten them.
Insert the Console Frame (87) into the Handrails
(71, 72). Attach the Console Frame with four
1/4" x 1" Screws (9). Start all four Screws, and
then tighten them. Be careful not to pinch the
Upright Wire (70).
9. Firmly tighten the two 5/16" x 1" Bolts (7) and
the four 5/16" x 1" Flat Head Screws (10) (only
one side is shown).
With the help of a second person, hold the con-
sole assembly near the Left Handrail (71) and
the Right Handrail (not shown).
Connect the ground wire from the console as-
sembly to the Console Ground Wire (89).
Next, connect the Upright Wire (70) to the con-
sole wire. See the inset drawing. The connec-
tors should slide together easily and snap
into place. If they do not, turn one connector
and try again. IF YOU DO NOT CONNECT
THE CONNECTORS PROPERLY, THE CON-
SOLE MAY BECOME DAMAGED WHEN YOU
TURN ON THE POWER. Then, remove the
wire tie from the Upright Wire.
8
87
13
11
9
71
70
9
Ground Wire
89
Console
Wire
70
11
13
11
9
31
72
Console
Assembly
Console
Wire
70
7
71
10
Wire
Tie