Assembly - NordicTrack T22.0 Treadmill User Manual

ASSEMBLY

• A ssembly requires two persons.
• P lace all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish assembly.
• T he underside of the walking belt is coated with
high-performance lubricant. After shipping, there
may be some lubricant on top of the walking belt
or on the shipping carton. This is normal. If there
is lubricant on top of the walking belt, wipe it off
with a soft cloth and a mild, non-abrasive cleaner.
1. Make sure that the power cord is unplugged.
Place a piece of cardboard below the rear of the
Frame (56) to protect the floor or carpet.
A ttach the Left Wheel Cap (96) to the left side of
the Base (97) with two #8 x 3/4" Screws (1).
Attach the Right Wheel Cap (not shown) to
the Base (97) in the same way.
2. P ull the Upright Wire (84) and the Base Ground
Wire (94) through the indicated hole in the Base
(97).
A ttach the Base Ground Wire (94) to the Base
(97) with a #8 x 1/2" Ground Screw (9).
P ress the Grommet (81) into the square hole in
the Base (97).
• T o identify small parts, see page 6.
• A ssembly requires the following tools:
the included hex key
one adjustable wrench
one Phillips screwdriver
To avoid damaging parts, do not use power tools
for assembly.
1
97
1
2
Hole
84
9
7
56
96
Cardboard
81
94
97