Environment Concerns - Electrolux EKG603202 User Manual

c) 37 mbar for LPG, propane only.
3. Turn the taps off and disconnect the
pressure gauge.
4. Make sure that all burners work correct-
ly.
Checking the grill
1. Put in the grill pan containing the grid.
2. Light the grill burner by turning the grill
control knob to the symbol
3. Release the knob when the burner
comes on.
Checking the hob burners
1. Lift the lid.
2. Put in the burner crowns and caps.
Make sure that they are correctly seat-
ed.
3. Put in the pan supports.
4. Check each of the burners in turn by
turning the burner control knob to the
symbol .
5. Release the knob when the burners
come on.
Checking the lid shut-off device
1. Lift the lid.
2. Light one of the hob burners.
3. Close the lid. There should be no gas
supply to the hob burners. The burner
goes out.
4. Turn the burner off and lift the lid. The
gas supply should be restored to the
hob burners, when you turn the knob
on.
Checking the main oven
1. Turn the gas oven control knob to the
symbol .

ENVIRONMENT CONCERNS

The symbol on the product or on its
packaging indicates that this product may
not be treated as household waste. Instead
it should be taken to the appropriate
collection point for the recycling of electrical
and electronic equipment. By ensuring this
product is disposed of correctly, you will
help prevent potential negative
consequences for the environment and
human health, which could otherwise be
caused by inappropriate waste handling of
2. When the oven burner comes on, the
gas at first flows to the oven burner
slowly, at the FSD by-pass rate.
3. When the FSD heat sensor is heated
sufficiently, it opens the FSD valve. The
main gas stream flows to the burner.
4. After 1 minute make sure that the flame
covers the full width of the burner and is
stable.
.
5. Set the oven control knob to
close the oven door. After about 10 mi-
nutes the flame size should decrease.
6. Turn the control knob off and check that
the oven flames go out.
Electrical installation
Warning! Only a qualified and
competent person must do the
electrical installation.
The manufacturer is not responsible if
you do not follow safety precautions
from chapter "Safety information".
This appliance is supplied with a main plug
and a main cable.
Connect the phases correctly, if you do
not connect, spark generator will work
all the time.
MANUFACTURER:
ELECTROLUX POLAND Sp.z o.o..
ul.Kazimierza Odnowiciela 28
58-100 Świdnica - POLAND
this product. For more detailed information
about recycling of this product, please
contact your local council, your household
waste disposal service or the shop where
you purchased the product.
electrolux 21
and